Introduction To Dhcp Server; Usage Of Dhcp Server; Chapter 2 Dhcp Server Configuration; Irf Support - Huawei Quidway S3900 Series Operation Manual

Operation Manual - DHCP
Quidway S3900 Series Ethernet Switches-Release 1510

Chapter 2 DHCP Server Configuration

Note:
The contents of this chapter are only applicable to the S3900-EI series among S3900
Series Switches.

2.1 Introduction to DHCP Server

2.1.1 Usage of DHCP Server

Generally, DHCP servers are used in the following networks to assign IP addresses:
Large-sized networks, where manual configuration method bears heavy load and
is difficult to manage the whole network in centralized way.
Networks where the number of available IP addresses is less than that of the
hosts. In this type of networks, IP addresses are not enough for all the hosts to
obtain a fixed IP address, and the number of on-line users is limited (such is the
case in an ISP network). In these networks, a great number of hosts must
dynamically obtain IP addresses through DHCP.
Networks where only a few hosts need fixed IP addresses and most hosts do not need
fixed IP addresses.

2.1.2 IRF Support

In an IRF (intelligent resilient framework) system, DHCP servers operate in a
centralized way to fit the IRF environment.
DHCP servers run (as tasks) on all the units (including the master unit and the
slave units) in a Fabric system. But only the one running on the master unit
receives/sends packets and carries out all functions of a DHCP server. Those
running on the slave units only operate as the backup tasks of the one running on
the master unit.
When a slave unit receives a DHCP-REQUEST packet, it redirects the packet to
the DHCP server on the master unit, which returns a DHCP-ACK/DHCP-NAK
packet to the DHCP client and at the same time backs up the related information
to the slave units. In this way, when the current master unit fails, one of the slaves
can change to the master and operates as the DHCP server immediately.
Huawei Technologies Proprietary
2-1
Chapter 2 DHCP Server Configuration