Configuring Radius Accounting Servers - Huawei Quidway S3900 Series Operation Manual

Operation Manual – AAA & RADIUS & HWTACACS & EAD
Quidway S3900 Series Ethernet Switches-Release 1510
Caution:
The authentication response sent from the RADIUS server to the RADIUS client
carries the authorization information. Therefore, no separate authorization server
can be specified.
In an actual network environment, you can either specify two RADIUS servers as
the primary and secondary authentication/authorization servers respectively, or
specify
authentication/authorization servers.
The IP address and port number of the primary authentication server used by the
default RADIUS scheme "system" are 127.0.0.1 and 1645.

1.4.3 Configuring RADIUS Accounting Servers

Table 1-14 Configure RADIUS accounting server
Operation
Enter system view
Create a RADIUS
scheme and enter
its view
Set the IP address
and port number of
the
RADIUS
accounting server
Set the IP address
and port number of
the
RADIUS
accounting server
Enable
stop-accounting
packet buffering
Set the maximum
number
transmission
attempts
buffered
stop-accounting
packets.
only one server
Command
system-view
radius
radius-scheme-name
primary
primary ip-address
[ port-number ]
secondary accounting
secondary ip-address
[ port-number ]
stop-accounting-buffer
enable
of
retry stop-accounting
of the
retry-times
Huawei Technologies Proprietary
Chapter 1 AAA & RADIUS & HWTACACS
as both the
—
Required
scheme
By default, a RADIUS scheme
named "system" has already
been created in the system.
Required
accounting
By default, the IP address and
UDP port number of the primary
accounting server are 0.0.0.0 and
1813.
Optional
By default, the IP address and
UDP
secondary accounting server are
0.0.0.0 and 1813.
Optional
By
packet buffering is enabled.
Optional
By default, the system tries at
most 500 times to transmit a
buffered stop-accounting request.
1-25
Configuration
primary and secondary
Description
port number of
default, stop-accounting
the