Configuration Procedure - Huawei Quidway S3900 Series Operation Manual

Operation Manual – VLAN VPN
Quidway S3900 Series Ethernet Switches-Release 1510

1.5.3 Configuration Procedure

1) Configure Switch A and Switch C.
As the configuration performed on Switch A and Switch C is the same, configuration on
Switch C is omitted.
# Set the TPID value of Ethernet1/0/2 port of Switch A to 0x9100, and add the port to
VLAN 10.
<SwitchA> system-view
[SwitchA] vlan 10
[SwitchA-vlan10] quit
[SwitchA] interface Ethernet1/0/2
[SwitchA-Ethernet1/0/2] vlan-vpn tpid 9100
[SwitchA-Ethernet1/0/2] port link-type trunk
[SwitchA-Ethernet1/0/2] port trunk permit vlan 10
# Configure Ethernet1/0/1 port of Switch A to be a VLAN-VPN port and add it to VLAN
10.
[SwitchA] interface Ethernet1/0/1
[SwitchA-Ethernet1/0/1] port access vlan 10
[SwitchA-Ethernet1/0/1] vlan-vpn enable
[SwitchA-Ethernet1/0/1] quit
2) Configure Switch B
Because Switch B comes from another vendor, the commands involved may differ from
those for S3900 series switches. So only the operations are listed, as shown below:
Configure Ethernet3/1/1 and Ethernet3/1/2 ports of Switch B to be trunk ports.
Add the two ports to VLAN 10.
Huawei Technologies Proprietary
1-7
Chapter 1 VLAN-VPN Configuration