Auto Detect Configuration Example - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Auto Detect
Quidway S3900 Series Ethernet Switches-Release 1510
Table 1-2 Display auto detect configuration
Display the configuration of
a detecting group

1.1.3 Auto Detect Configuration Example

I. Network requirements
Create detecting group 10 on Switch A and add two IP addresses, 10.1.1.4 and
192.168.2.2, to it to test the reachability to the two IP addresses.
Specify to return reachable as the detecting result if one of the two IP addresses
is reachable, that is, specify the or keyword for the option command.
Set the detecting interval to 60 seconds; the maximum number of retries to 3,
and the timeout time to 3 seconds.
II. Network diagram
VLAN 1 VLAN 1
Ethernet 1/0/1 Ethernet 1/0/1
Ethernet 1/0/1 Ethernet 1/0/1
192.168.1.1 192.168.1.1
192.168.1.1/24 192.168.1.1/24
VLAN 2 VLAN 2
Ethernet 2/0/1 Ethernet 2/0/1
Ethernet 2/0/1 Ethernet 2/0/1
192.168.2.1 192.168.2.1
192.168.2.1/24 192.168.2.1/24
Figure 1-1 Network diagram for auto detect configuration
III. Configuration procedure
# Enter system view.
<Quidway> system-view
# Create detecting group 10.
[Quidway] detect-group 10
# Specify to detect the IP address of 10.1.1.4, taking the IP address of 192.168.1.2 as
the next hop and setting the detecting number to 1.
[Quidway-detect-group-10]
192.168.1.2
Operation
192.168.1.2/24 192.168.1.2 192.168.1.2/24 192.168.1.2
Switch A Switch A Switch A Switch A
192.168.2.2/24 192.168.2.2 192.168.2.2/24 192.168.2.2
Huawei Technologies Proprietary
Command
display detect-group
[ group-number ]
10.1.1.3/24 10.1.1.3 10.1.1.3/24 10.1.1.3
Switch B Switch B Switch B Switch B
Switch D Switch D Switch D Switch D
20.1.1.2/24 20.1.1.2 20.1.1.2/24 20.1.1.2
detect-list 1 ip
1-2
Chapter 1 Auto Detect Configuration
Description
The display command
can be executed in any
view.
10.1.1.4/24 10.1.1.4 10.1.1.4/24 10.1.1.4
Switch C Switch C Switch C Switch C
address 10.1.1.4 nexthop