Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Configure the RP address
to
be
messages
Note:
In Anycast RP application, C-BSR and C-RP must be configured on different devices or
ports.
8.3.4 Configuring an MSDP Mesh Group
Configure a mesh group name on all the peers that will become members of the MSDP
mesh group, so that the peers are fully connected with one another in the mesh group.
Table 8-5 Configure an MSDP mesh group
Operation
Enter system view
Enter MSDP view
Add an MSDP peer in a
mesh group
Note:
Before you configure an MSDP mesh group, make sure the routers must be fully
connected with one another.
The same group name must be configured on all the peers.
If you add the same MSDP peer into multiple mesh groups, only the latest
configuration takes effect.
originating-rp
carried
in
SA
interface-type
interface-number
system-view
msdp
peer
mesh-group name
Huawei Technologies Proprietary
Command
Command
peer-address
8-10
Chapter 8 MSDP Configuration
Description
Required
By
default,
the
address in SA messages
is
the
RP
address
configured by PIM.
Description
—
—
Required
This command must be
configured
on
all
peers,
so
you
must
configure this command
for multiple times.
RP
the