Enabling Information Output To A Monitor Terminal - Huawei Quidway S3900 Series Operation Manual

Operation Manual – Information Center
Quidway S3900 Series Ethernet Switches-Release 1510

1.2.4 Enabling Information Output to a Monitor Terminal

Table 1-8 lists the related configurations on the switch.
Table 1-8 Enable information output to a monitor terminal
Operation
Enter system view
Enable
information center
Enable information
output to Telnet
terminal or dumb
terminal
Define
information source
Set the format of
time stamp
Note:
When there are multiple Telnet users or dumb terminal users, some configuration
parameters (including module filter, language and severity level threshold settings)
are shared between them. In this case, change to any such parameter made by one
user will also be reflected on all other user terminals.
To view debugging information of specific modules, you need to set the information
type as debug when defining the information source, and enable debugging for
corresponding modules through the debugging command as well.
To view the debugging/log/trap output information on the monitor terminal, you should
enable the corresponding debugging/log/trap display function on the switch.
Command
system-view
the
info-center enable
info-center
channel { channel-number |
channel-name }
info-center
{ modu-name | default }
an channel { channel-number |
channel-name } [ { log | trap
| debug } { level severity |
state state } ]*
info-center
{ log | trap | debugging }
{ boot | date | none }
Huawei Technologies Proprietary
1-10
Chapter 1 Information Center
—
Optional
By default, the information
center is enabled.
Required
By default, a switch outputs
monitor
log/debugging/trap
information to user terminal
through information channel
1.
source
Required
Optional
This is to set the time stamp
timestamp
format for log/debugging/trap
information output.
This determines how the time
stamp is presented to users.
Description