Timer And Maximum User Number Configuration - Huawei Quidway S3900 Series Operation Manual

Operation Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510
Operation
Set port
control mode for
specified ports
Set port
method
specified ports
Set authentication
method for 802.1x
users
Caution:
802.1x-related configurations can all be performed in system view. Port access
control mode and port access method can also be configured in port view.
If you perform a configuration in system view and do not specify the interface-list
argument, the configuration applies to all ports. Configurations performed in
Ethernet port view apply to the current Ethernet port only and the interface-list
argument is not needed in this case.
802.1x configurations take effect only after you enable 802.1x both globally and for
specified ports.
When the device itself functions as the authentication server, the 802.1X
authentication method cannot be configured to EAP.

1.4 Timer and Maximum User Number Configuration

Table 1-2 Configure 802.1x timers and the maximum number of users
Operation
Enter system view
Command
dot1x
access
{ authorized-force
unauthorized-force | auto }
[ interface interface-list ]
access dot1x
for { macbased | portbased }
[ interface interface-list ]
dot1x
authentication-method
{ chap | pap | eap }
Command
system-view
Huawei Technologies Proprietary
1-14
Chapter 1 802.1x Configuration
Optional
port-control
|
By default, an 802.1x-enabled
port operates in an auto
mode.
Optional
The
port-method
method
MAC-address-based (that is,
the
used by default).
Optional
By default, a switch performs
CHAP authentication in EAP
terminating mode.
—
Description
default port access
macbased keyword is
Description
is