Igmp Configuration - Huawei Quidway S3900 Series Operation Manual

Hide thumbs Also See for Quidway S3900 Series:
Table of Contents

Advertisement

Operation Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Figure 6-2 is an IGMP Proxy diagram for a leaf network.
Configure Switch B as follows:
Enable multicast routing on VLAN interface 1 and VLAN interface 2, and then
configure the PIM protocol on it. And configure the IGMP protocol on
VLAN-interface 1 at the same time.
On VLAN interface 2, configure VLAN interface 1 as the outbound IGMP Proxy
interface to external networks. You must enable the IGMP protocol on the interface
first, and then configure the igmp proxy command.
Configure Switch A as follows:
Enable multicast routing and configure the IGMP protocol on VLAN interface 1.
Configure the pim neighbor-policy command to filter PIM neighbors in the
network segment 33.33.33.0/24. That is, Switch A does not consider Switch B as
its PIM neighbor.
In this case, when Switch B of leaf network receives from VLAN interface 2 an IGMP
join or IGMP leave message sent by the host, it will change the source address of the
IGMP information to the address of VLAN interface 1: 33.33.33.2 and send the
information to VLAN interface 1 of Switch A. For Switch A, this works as if there is a
host directly connected to VLAN interface 1.
Similarly, when Switch B receives the IGMP general group or group-specific query
message from the Layer 3 Switch A, it will also change the source address of the query
message to the IP address of VLAN interface 2: 22.22.22.1 and send the message from
VLAN interface 2.
In Figure 6-2, VLAN interface 2 of Switch B is called the client and VLAN interface 1 of
Switch B is called the proxy.

6.2 IGMP Configuration

You cannot perform other IGMP configuration tasks until you enable the IGMP protocol
after multicast is enabled.
IGMP configuration tasks include:
Table 6-1 Configuration task overview
Operation
Configure IGMP version
Configure IGMP query
packets
Configure IGMP multicast
groups on the interface
Description
Optional
Optional
Optional
Huawei Technologies Proprietary
6-5
Chapter 6 IGMP Configuration
Related section
Section 6.2.1
Configuring IGMP
Version
Section 6.2.2
Configuring IGMP
Query Packets
Section 6.2.3
Configuring IGMP
Multicast Groups on the Interface

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents