Dldp Configuration; Dldp Configuration Tasks - Huawei Quidway S3900 Series Operation Manual

Operation Manual - DLDP
Quidway S3900 Series Ethernet Switches-Release 1510
down unidirectional links. On the contrary, if too short an interval is set, network
traffic increases, and port bandwidth is reduced.
DLDP does not process any LACP event, and treats each link in the aggregation
group as independent.

1.2 DLDP Configuration

1.2.1 DLDP Configuration Tasks

The following table describes the DLDP basic configuration tasks:
Table 1-7 DLDP configuration tasks
Enter system view
Enable
DLDP
Set the authentication mode and
password
Set the interval of sending DLDP
packets
Set the delaydown timer
Set the DLDP handling mode
when an unidirectional link is
detected
Operation
Enable DLDP
globally
Enter
Ethernet
Enable
port view
DLDP
on a
Enable
port
DLDP on
a port
Huawei Technologies Proprietary
Command
system-view
dldp enable
interface { interface-type
interface-number
interface-name }
dldp enable
dldp authentication-mode
{ none |
simple-password
md5-password }
dldp interval integer
dldp delaydown-timer
delaydown-time
dldp
unidirectional-shutdown
{ auto | manual }
1-7
Chapter 1 DLDP Configuration
Description
-
Required.
|
By default,
DLDP
disabled
Optional
simple
By default, the
| md5
authentication
mode is none
Optional.
default,
interval is 10
seconds
Optional
By default, the
delaydown
timer expires
after 1 second
it is triggered.
Optional
By default, the
handling mode
is auto
is
By
the