The Command Interface - Fujitsu Siemens Computers SX series User Manual

Performing DR

10.2.2 The command interface

The commands described below can only be executed under the root ID and in the
partition(s) concerned.
Information functions – Partitions, system boards and associated resources
1. /opt/FJSVhwr/sbin/drcstat -board [all] -xpar
The
drcstat
statuses in the partitions (current partition, next partition after a Partition Solaris reboot). If
is not specified, only those system boards are listed which are currently assigned to the
all
home partition.
# drcstat -board all -xpar
SB
---- -- ----------------- --- -------- ---------- --------
00-0
00-1
00-2
00-3 12 Configured
01-0
01-1
01-2
01-3 13 ---
In this example the first 5 XSBs are operating, the first 2 are being used by the partition (with
PID) 0 (here named 00), and the next 3 by the partitions 1, 2 and 3 (here named 01, 02,
03). The XSBs are permanently assigned to the partitions, i.e. also after any Solaris reboot
as
Next_PID = PID
For XSB 01-1, which is not operating, no value is assigned to the
XSB is in the pool of free XSBs and could be attached to any of the partitions.
XSBs 01-2 and 01-3 do not exist on this server.
308
command lists the system boards of the machine and their configuration
BN Status (Detail)
0 Configured
4 Configured
8 Configured
1 Configured
5 Disconnected
9 ---
applies in a ll cases.
PID Next_PID Board_Type CPU(MHz)
00 00
00 00
01 01
02 02
03 03
-- --
-- --
-- --
Dynamic Reconfiguration
0x34 1890
0x34 1890
0x34 1890
0x34 1890
0x34 1890
0x34 1890
--- ---
--- ---
Next_PID
setting, i.e. the
U41272-J-Z385-3-76