Configuring The Openssh Daemon - Fujitsu Siemens Computers SX series User Manual

Access with Secure Shell

6.3.2 Configuring the OpenSSH daemon

Before you can use the software just installed you must configure the ssh daemon for X11
forwarding. To do this, on the BS2000 partitions and on the SMC of the model series up to
and including SX140 edit the file /opt/SMAWPlus/etc/sshd_config or, on the SMC as
of the SX150 model series, the file /etc/ssh/sshd_config as follows:
Ê If they exist, change the lines
#X11Forwarding no
#X11DisplayOffset 10
#X11UseLocalhost yes
to these or insert the relevant lines:
X11Forwarding yes
X11DisplayOffset 10
X11UseLocalhost yes
Next, add a new line with this content:
Ê
XAuthLocation /usr/openwin/bin/xauth
Ê Restart the active ssh daemon, using the following call:
On the BS2000 partitions and on the SMC up to and including SX140:
/etc/init.d/openssh-SMAWPossh restart
As of SX150 on the SMC:
/etc/init.d/sshd restart
This will activate the changes.
This operation completes installation and configuration on the target system.
146
Remote operation via PC
U41272-J-Z385-3-76