Fujitsu Siemens Computers SX series User Manual page 353

X2000 messages
IODE022 CHPID xx module error: module stopped
Meaning
Module stop error handling has been terminated with an error or due to the presence of a
persistent error. The module has been stopped and identified as defective. A logout has
been stored.
Response
The error could not be eliminated by the error handling operation. The result of the analysis
of the corresponding logout should be evaluated and maintenance undertaken. The module
is not available again until channel initialization has been repeated following a Solaris boot
operation or the RMAssist command chinit.
IODE040 Error simulation initiated
Meaning
An error simulation has been activated. The error simulation may trigger error handling.
Response
No maintenance response is required.
IODE050 CHPID xx Vary channel path offline
Meaning
This message is issued at the start of the MSSF call CHPOFF - vary channel path
offline. This message is for diagnostic purposes and is output only if the service engineer
specifies this explicitly.
Response
See the messages IODE051, IODE052, IODE053, IODE054, IODE055.
IODE051 CHPID xx has been varied offline
Meaning
The MSSF call CHPOFF - vary channel path offline has switched the module to the
offline state.
Response
No maintenance response is required.
IODE052 CHPID xx was already offline
Meaning
The module was already in the offline state at the time of the MSSF call CHPOFF - vary
channel path offline.
Response
No maintenance response is required.
U41272-J-Z385-3-76
IOD messages
353