Figure 108: Setting A Disk Copy Under Psr; Copy - Fujitsu Siemens Computers SX series User Manual

Global X2000 functions
9.7.2.5

Copy

In the off-line mode PSR enables the disk copying; the full content of a hard disk can be
copied to another hard disk. To do this, select the hard disk to be copied in the same way
as you would if you were saving. This disk is referred to below as the "source disk". The
selection is made with the RETURN key because there is no sub-selection (selection of
individual slices) for copying. After the source disk has been selected an area is opened on
the right in which the target disk must be selected. The following cannot be selected:
PSR-X V3.0A
Oct 21 2004
Source Disk
c0t0d0s0
>c0t1d0s0
c1t2d0s0
c1t4d0s0
c1t5d0s0
Use CURSOR to move, ENTER to select, CTRL c to abort

Figure 108: Setting a disk copy under PSR

– the source disk
– disks which have another geometry
– disks whose size is not large enough for the disk partition table adapted to the changed
geometry
The sub-screen with the slices of the source disk, which is displayed in the centre, is for
information only. Individual slices cannot be selected.
After the source disk and target disk have been selected, another prompt appears which
must be acknowledged with c (continue).
U41272-J-Z385-3-76
Copy
Disk c1t2d0s0 17423.437 MB
>ROOT SWAP
NULL NULL
Target Disk
Slices
BACKUP c0t0d0s0 VAR
c0t1d0s0
BS2000 BOOT
>c1t2d0s0
c1t4d0s0
c1t5d0s0
Offline PSR
281