Operating Bs2000 Instances; Starting Bs2000; Bs2000 Console Mode - Fujitsu Siemens Computers SX series User Manual

7 Operating BS2000 instances

7.1 Starting BS2000

To start BS2000, you will first need a BS2000 console screen (see the following
"Accessing BS2000 console
[F2] key to branch into the Main KVP Function Menu (see
(see page
lation, you must specify the IPL parameters (IPL device, IPL console and, if channel
devices are available, the IORSF level) and send the menu. The system automatically
switches back to the BS2 console screen. You can monitor the runtime messages of the IPL
on this.
The system remembers the last IPL data and displays it at the next IPL. Normally, therefore,
you do not have to make any entries in the IPL screen on subsequent starts.
You can automatically boot BS2000 after starting Solaris if you configure the "Automatic
IPL" (see
up type "A" has been set, the procedure will stop at this query prompt and await a response.

7.2 BS2000 console mode

The BS2000/OSD operating system is operated in BS2000 console mode. The necessary
commands are described in the
If these are BCAM commands they are contained in the manual "openNet Server
(BS2000/OSD) – BCAM" [17]. In addition to commands, responses to BS2000 system
messages are required. All BS2000/OSD-BC system messages are described in the
"System Messages" [13] manuals.
U41272-J-Z385-3-76
mode"). When the status bar appears in the first line, use the
169). Now you can select IPL - start BS2000 . Here, on the first call after instal-
page 215). If the BS2000 startup procedure issues a query even though a start
"Commands, Volumes 1 -
page 164). Select SVP commands
5" manuals [11].
section
159