Dynamic Reconfiguration
The -reset parameter controls immediate reconfiguration of reconfiguration via a reboot:
–
If the -reset parameter is not specified, the reconfiguration process is initiated immedi-
ately.
–
If the -reset parameter is specified, the reconfiguration process is planned for the next
time Solaris is rebooted.
A drc command with the -disconnect and -reset options is canceled again and
reversed by a later command for the same XSB with the -connect and -reset options.
Note
10.2.3 Execution of DR, diagnosis and problem handling
Execution and errors with DR-connect
A normal DR-connect run consists of the following phases:
–
SB self-test phase (only if the system board is in the SB pool)
–
checkadd
–
preadd
–
Kernel phase (Solaris)
–
postadd
The DR-connect actions for BS2000 or VM2000 are part of the postadd phase.
Execution and errors with DR-disconnect
A normal DR-disconnect run consists of the following phases:
–
checkremove
–
preremove
–
Kernel phase (Solaris)
–
postremove
–
SB self-test phase
(exception: the system board is returned to the SB pool)
The DR-disconnect actions for BS2000 or VM2000 are part of the preremove phase.
U41272-J-Z385-3-76
Reconfiguration via a reboot can also be performed using the Machine Adminis-
tration Menu on the SMC.
Performing DR
313