Fujitsu Siemens Computers SX series User Manual page 236

Magnetic tape cartridge devices
i
236
Notes
– You are recommended to configure devices before the BS2000 involved are
started. If a device is configured while a BS2000 system is in operation, an
ATTACH-DEVICE takes place automatically in this syxstem after the first step.
This must be undone with a manual DETACH-DEVICE as the second step cannot
be performed while the device is in the ATTACHED state.
– When performing the second step, you are recommended to highlight the root
of the tree hierarchy in the left-hand part of the PRIMEPOWER ServerView
main display since the Available nodes box only lists PRIMEPOWER ServerView
nodes that are located in this highlighted area.
– For a BS2000 system not listed in the Switched nodes box, the MTC device
retains its isolated state. In X2000 there is no coordination between the
accesses of this system and the accesses of the systems listed in the Switched
nodes box. The MTC device may thus only be used when the second step has
been completed for all systems which can access the MTC device.
Global X2000 functions
U41272-J-Z385-3-76