Bs2000 $Dialog Mode - Fujitsu Siemens Computers SX series User Manual

Operating BS2000 instances

7.3.2 BS2000 $DIALOG mode

If you wish to work in $DIALOG mode, you must establish a connection to the $DIALOG
partner in the target computer. Select the relevant function from the menu to control the
connection.
The $DIALOG partner of the local BS2000 system is normally preset as the standard
partner. You can connect to the local BS2000 system via the name LBS20$DIALOG
(LOCLAN).
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
................................................................................
CN04 VERBUNDEN MIT LBS20$DIALOG.................................................
................................................................................
................................................................................
<...............................................................................
% JMS0150 INSTALLATION '
ENTER '/SET-LOGON-PARAMETERS' OR '?'............................................
/...............................................................................
LTG
Now you can enter the command SET-LOGON-PARAMETERS and then work in BS2000.
If the SET-LOGON-PARAMETERS command is rejected, the maximum number of dialog
processes in BS2000 may have been exceeded. If this occurs, you can increase the limit as
system administrator or try again later.
If the opening screen does not appear in $DIALOG mode, the system is not yet available
(i.e. not loaded or not yet loaded completely).
Ê Check that the BCAM of BS2000 is ready (e.g. with the command /BCSHOW).
U41272-J-Z385-3-76
The following screen format is output on the terminal (the precise screen format
depends on the version of BS2000 used on the partner computer):
ccc-x', BS2000 VERSION 'Vnnn', HOST 'PP80022': PLEASE
EM9750 mode
TAST
189