Hal Messages - Fujitsu Siemens Computers SX series User Manual

HAL messages

13.4 HAL messages
HAL0001 MDEBUG ACTIVE
Meaning
The master debugger mdebug has been started
HAL0002 MDEBUG INCATIVE
Meaning
The master debugger mdebug has been stopped
HAL0140 HAL ABORT GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP
Meaning
The HAL on this processor has detected an inconsistency and has terminated the
processing of BS2000 instructions on all processors.
Response
Please execute the following commands as 'root' user in Solaris.
# /opt/SMAW/X2000/bin/save_diag
or via the event screen
sx.save_diag
A full description of the save diag command can be found in
diagnostic documents" on page
HAL0141 HAL ABORT GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP OTHER GP
Meaning
The HAL on another processor has detected an inconsistency and has terminated the
processing of BS2000 instructions on all processors.
This message is a continuation message from HAL0140.
HAL0211 MDEBUG STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP
Meaning
The master debugging interface has been used by either mdebug or RMAassist to halt the
processing of BS2000 instructions. This may happen as a normal part of IPL processing or
if mdebug is being used to examine the system.
Response
If mdebug is being used to examine the system the mdebug command bg will restart the
processor.
358
337. Additionally try to take a SLED.
X2000 messages
section "Create X2000
U41272-J-Z385-3-76