Fujitsu Siemens Computers SX series User Manual page 103

Functions of the System Management Console
7. When a prompt appears, start the restore process by entering the following command:
SMC# dd if=/dev/rmt/0 of=/dev/rdsk/c0t0d0s2 bs=1024k
When you enter this command, ensure that the value of the bs option (buffer size) is
identical to the value used when the backup was created.
The restore process for the 8 GB hard disk drive takes approximately one hour.
The larger the hard disk capacity, the longer the restore process will take.
8. Press the eject button of the DAT tape drive to remove the data cartridge from the drive.
9. Switch to OBP mode by entering the following command:
SMC# /usr/sbin/shutdown -g0 -y -i0
10. Enter the following command to restart:
ok boot
When the login window of the System Console Software appears, you can start normal
system operation. Remove the Solaris CD-ROM from the CD-ROM drive.
11. Where necessary, you must restore the configuration data of the System Console
Software. For more detailed explanations, see
the System Console Software" on page
U41272-J-Z385-3-76
Backing up/restoring the SMC
section "Restoring configuration data of
98.
103