Fujitsu Siemens Computers SX series User Manual page 265

Global X2000 functions
BS2000 standard applications
The ATNS uses the file /etc/opt/SMAW/X2000/tnsrem_data to create the TNS
entries for local BS2000 standard applications. The call is issued automatically after the
successful configuration of a local BS2000 communication device (LAN port).
If the file /etc/opt/SMAW/X2000/tnsrem_data is not present, it is generated
automatically when ATNS is called and contains the following default values:
$AC
$CONSOLE
$DIALOG
$VMCONS
$FJAM001
$FJAM002
$FJAM003
$FJAM004
This automatically creates the following TNS entries:
<BS2000-node-name> <application>
You can process the file tnsrem_data in an editor. To activate the changes that you
make, you must deconfigure and then reconfigure the BS2000 communication device
in question via PRIMEPOWER ServerView.
i
The following command does the same thing in one go (without any effect on active
connections):
Here <channel> is the channel number and <unit> is the lower unit number of the
BS2000 communication device pair.
Notes on deconfiguration
–
–
U41272-J-Z385-3-76
$FJAM005
A01BS2
A02BS2
A03BS2
A04BS2
A05BS2
A06BS2
A07BS2
Deconfiguring or configuring result in the termination of all connections via this
port.
atns <channel> <unit> conf
You can only delete those application names, which are contained in the file
tnsrem_data at the time of deconfiguration.
If application names are deleted after the configuration of a LOCLAN device
emulation, the deleted application names remain listed in TNS and can then be
purged by means of the command tnsxdel or the menu CMXCUI.
Local and remote communications
A08BS2
A96BS2
A97BS2
A98BS2
A99BS2
PRSC
OMNIS
(e.g. LBS20$DIALOG)
265