Fujitsu Siemens Computers SX series User Manual page 172

BS2000 console mode
iohdump – dump IOH memory
This command creates an IOHDUMP in the directory /var/opt/SMAW/X2000/dump.
Name of the file: RMA_R.<abend code>.<DateTime>.<X2000 version>
If no abend code is available, SLD000 is used.
The number of IOHDUMPs is limited to ten. When the maximum number has been
reached, the oldest file in the directory /var/opt/SMAW/X2000/dump is deleted.
iosdump – dump IOS memory
This command creates a compressed IOSDUMP in the directory
/var/opt/SMAW/X2000/dump/channel.
Name of the files:
IOSDUMP.<DateTime>.Z
chinit – channel initialization
This command should be called if the channels do not function after an IPL.
After the channel system has been initialized, an IPL is required.
!
iorsf – report iorsf files
If channels are connected, you can output a list of the iorsf files with this command.
param – report actual default parameters for IPL
You can display the current IPL parameters on the screen with this command.
Example
2 actual default parameters for IPL
IPL load-device: D6
consol-device:
IORSF-level:
No IPL parameters are stored immediately after a first installation. An error message is
output.
172
CAUTION!
BS2000 operation must be stopped first. A BS2000 system run is canceled
when this command is executed. If the BS2000 processor has not already been
stopped, the following message appears:
BS2000 is already running – restart [y/n]
In the message the n must be replaced by y, otherwise the channel initialization
is not performed.
Z0
-
Operating BS2000 instances
n
U41272-J-Z385-3-76