Parallel Interface For Printers; Installing A Parallel Interface - Fujitsu Siemens Computers PRIMERGY TX200 S4 Server Options Manual

10

Parallel interface for printers

V
CAUTION!
Observe the safety instructions in the
page 15ff.
10.1

Installing a parallel interface

Ê Open the server as described in the
Ê Remove the system fan 1, the system fan 2 and the traverse as described in
the section "System fans and traverse" on page
Ê Install the parallel interface as described in the
expansion board" on page
Figure 50: Routing the cable
Ê Route the cable as shown in the photo.
Ê Connect the cable's connector to the parallel port connector on the system
board.
TX200 S4
chapter "Safety notes" on
chapter "Preparation" on page
58ff.
Options Guide
24ff.
section "Installing an
21ff.
67