Figure 115: Removing An Xsb (Example) - Fujitsu Siemens Computers SX series User Manual

Performing DR
In the example below XSB 01-1 (here named Systemboard_1-1) is removed immediately
(Disconnect immediatly option) and not assigned to another partition but to the pool of free
XSBs.

Figure 115: Removing an XSB (example)

Notes
The Disconnect at next reboot option (alternative to the Disconnect immediatly option) is the
equivalent of the -reset parameter in the drc command.
In the Next partition list a partition (default: none) can be selected which the XSB is
assigned to after it has been removed.
This is the equivalent of the -next <Partition ID> parameter in the
drc -disconnect command.
The drc command is described in the
In PRIMEPOWER ServerView the Move action is the basis for the DR workload distribution
application.
The Move action enables the sequence of DR-disconnect and DR-connect to be initiated which
is required to shift an XSB to another partition.
DR-disconnect removes the XSB from the partition which releases it and assigns it to the
receiving partition.
306
section "The command interface" on page
Dynamic Reconfiguration
U41272-J-Z385-3-76
308.