Sx.diag Command - Fujitsu Siemens Computers SX series User Manual

sx.diag command

12.2 sx.diag command
You can use this command to generate a Solaris system dump or to activate or deactivate
devices.
Command call
This command is issued in the EVENT screen (see
sx.diag <parameter>
Call formats
sx.diag
No action is performed The possible input values are output.
sx.diag sinixdump
A Solaris system crash is immediately initiated and a dump is generated.
!
sx.diag kdump
A prkdump is written to the directory /var/opt/SMAW/X2000/diag.
sx.diag sinixdet
All bus devices are disabled.
!
sx.diag sinixdet <chn> <unit>
The bus device with this chn-no./unit-no. is deactivated. In the case of a dual device
(with KVP/LAN), both devices are deactivated. A corresponding message is output.
i
336
CAUTION!
Only issue this command in exceptional cases. It is possible that file systems
will be destroyed the next time Solaris is started.
CAUTION!
If you issue this command while BS2000 is running, there is a risk that BS2000
will crash. It is usually better to disable a single device using the next command
(e.g. a specific tape device).
The chn/unit-no. must be entered in hexadecimal form.
Example: sx.diag sinixdet 0 03
section "EVENT mode" on page
What if ...
191):
U41272-J-Z385-3-76