Fujitsu Siemens Computers SX series User Manual page 101

Functions of the System Management Console
6. When a prompt appears, enter the command format. The system disks available for
selection are offered.
Example
#format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <sfdsk type1.0; ST320420A cyl 39533 alt 2 hd
16 sec 63>
/pci@1f,0/pci@1,1/ide@3/dad@0,0
Specify disk (enter its number):
Enter the number of the required system disk (in the example 0 for c0t0d0).
Close the menu with q (quit).
7. When a prompt appears, start the backup by entering the following command (use the
controller number which you have confirmed in Step 6):
SMC# dd if=/dev/rdsk/c0t0d0s2 of=/dev/rmt/0 bs=1024k
i
A prompt appears again when the backup is complete.
8. Press the eject button of the DAT tape drive to remove the data cartridge from the drive.
Then activate write protection by putting the write protection slider of the data cartridge
into the "write-protected" position.
9. Switch to OBP mode by entering the following command:
SMC# /usr/sbin/shutdown -g0 -y -i0
10. Enter the following command to restart the System Console Software:
ok boot
When the login window of the System Console Software appears, you can start normal
system operation. Remove the Solaris CD-ROM from the CD-ROM drive.
U41272-J-Z385-3-76
The backup of the 8 GB hard disk drive takes approximately one hour.
The larger the hard disk capacity, the longer the backup will take.
Backing up/restoring the SMC
101