Fujitsu Siemens Computers SX series User Manual page 359

X2000 messages
HAL0212 MDEBUG STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP BREAK-POINT
Meaning
A break point set by mdebug has been executed by the given processor. The processing of
BS2000 instructions has been halted.
Response
The mdebug command 'bg' will restart the processor.
HAL0213 MDEBUG STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP DATA TRAP
Meaning
The given processor has executed an instruction that has modified a virtual memory
address that is being watched for modification via mdebug. The processing of BS2000
instructions has been halted.
Response
If mdebug is being used to examine the system the mdebug command bg will restart the
processor.
HAL0214 MDEBUG STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP SAVE-STATE
Meaning
The master debugging interface has been used by either mdebug or RMAassist to halt the
processing of BS2000 instructions in preparation for a new IPL. This always happens as a
normal part of IPL processing.
HAL0215 MDEBUG SPIN
Meaning
The mentioned processor has interrupted the execution of BS2000 instructions due to a
breakpoint hit in HAL set by mdebug.
Response
The mdebug-command "bg" tries to restart the processors. If the breakpoint has been set
at a critical position in HAL further errors may occur.
HAL0221 MDEBUG START GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP
Meaning
The master debugging interface has been used by either mdebug or RMAassist to start the
processing of BS2000 instructions. This is not a normal part of IPL processing but the result
of administrator intervention with mdebug or RMAssist.
HAL0230 MDEBUG RESET GPXX
Meaning
The master debugging interface has been used by either mdebug or RMAassist to reset the
HAL internal interfaces and data structures for the given CPU. This is a normal part of IPL
processing.
U41272-J-Z385-3-76
GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP FW-STOP
HAL messages
359