Fujitsu Siemens Computers SX series User Manual page 238

Magnetic tape cartridge devices
Case B: X2000 not running
In PRIMEPOWER ServerView, remove the BS2000 system from the Switched nodes box
by using one of the remaining BS2000 systems. Under normal circumstances modifying
the configuration in this way is only possible when the system is communicating with all
the other BS2000 systems on the list in the Switched nodes box on the X2000 level.
The procedure is therefore as follows:
1. Execute the EVENT command sx.bs2mtcfetch -f tape-MN at one of the
2. In PRIMEPOWER ServerView, use this BS2000 system to change the configuration
3. Update the list in the Switched nodes box and click Ok. A prompt is displayed asking
In PRIMEPOWER ServerView, the new Switched nodes list is displayed for each of the
remaining BS2000 systems.
i
238
remaining BS2000 systems (see
communication is disrupted"
for the MTC device.
if you want to restrict the update of the node list to the accessible local copies. You
must respond Ok to this prompt.
If you want to reactivate a BS2000 system which - as described in case B - has been
removed from the Switched nodes list, you must delete the MTC device concerned for
this BS2000 system in the PRIMEPOWER ServerView. You can then reconfigure
the system as required and then add the BS2000 system to the other BS2000
systems using the procedure described above. The MTC device may not be used if
it can be accessed again by the system concerned and configuration has not been
completed.
section "Occupying an MTC device when X2000
below).
Global X2000 functions
U41272-J-Z385-3-76