Fujitsu Siemens Computers SX series User Manual page 360

HAL messages
HAL0311 BS2000 STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP DISABLED-WAIT
Meaning
A new PSW has been loaded by the given processor in which the wait bit is set and no inter-
rupts are enabled. As a result, the processing of BS2000 instructions has been halted. This
may occur as part of a normal shutdown or may be due to a system crash - SETS.
Response
If the BS2000 system is no longer running and was not terminated on purpose, please
perform a SLED to secure diagnostic information.
HAL0312 BS2000 STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP SIGP
Meaning
BS2000 stopped the given processor via a SIGP instruction. This is a normal during
BS2000 shutdown or when a CPU is detached but also occurs during a system crash or
SETS.
Response
If the BS2000 system is no longer running and was not terminated on purpose, please
perform a SLED to secure diagnose information.
HAL0313 BS2000 STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP SIGP RESET
Meaning
BS2000 has reset the given processor via a SIGP instruction.
HAL0314 BS2000 STOP GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP SIGP STORE-STATUS
Meaning
BS2000 requested, via the SIGP instruction, that diagnostic information about the current
state of the given processor is to be saved.
HAL0321 BS2000 START GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP SIGP
Meaning
BS2000 has started the given processor via the SIGP instruction.
HAL0322 BS2000 START GPXX SSSSSSSSSSSSSSSS PPPPPPPPPPPPPPPP IPL-RESTART
Meaning
The master debugging interface has been used by either mdebug or RMAassist to start the
processing of BS2000 instructions, directly after a new IPL boot block has been loaded.
This is the last step in normal IPL processing.
360
X2000 messages
U41272-J-Z385-3-76