Fujitsu Siemens Computers SX series User Manual page 255

Global X2000 functions
Node
Name
Type
Workmode
Mode
Station type
Station# 0-127
Communication
settings
Device node
Emulation options
U41272-J-Z385-3-76
Computer node on which the Transdata printer is to be set up.
Here, you specify the name of a printer which is configured in the
UNIX system and which is to be used for print output by the
emulation.
The system displays the printer type corresponding to the printer
entered under "Name".
buffered:
The print job is to be performed via the UNIX spool.
unbuffered:
The print job is to explicitly occupy the UNIX printer.
The emulation converts the character codes and
CHAR:
control sequences.
GRAPH: The emulation runs without performing a conversion.
You can choose between the actual printer type (e.g. 9014) or the
universal station type 8122.
The station name is formed internally from the station type and the
entered "Station#" (e.g. E9014#00 / E8122#7F). The station name
must be specified in order to define a remote printer in the
ADD_SPOOL_DEV function of the SPSERVE utility.
Only for serial device connections (not relevant for the SX servers).
The system displays the IP address and the port number via which
the printer is accessed.
Here you can specify options, for example for diagnostic purposes.
If you specify multiple options then you must separate them using
spaces.
The following options are available for print stations in unbuffered
mode:
-seh This switch must be set if the emulation operates a printer
which is connected via LAN and SEH Printserver.
-trace The emulation's trace function is activated.
In the case of print stations in buffered mode, it is possible to control
the trace options of the participating EMDS emulation (switches
-P 1/2/3, -D, -E and -L).
Configuring printers
255