Inputs - Fujitsu Siemens Computers SX series User Manual

BS2000 console mode

7.2.4 Inputs

KVP supports 97801 and dtterm terminals.
A BS2000 operator terminal normally operates in output mode. Press a character key to
switch to input mode. The cursor is positioned in the input line (line 24 on the screen). If the
input line is not large enough, additional input lines are made available. The maximum input
length is 256 characters.
If an input was commenced but after 16 seconds nothing further was input, the warning
INPUT??? is output in the KVP status bar and a warning signal sounds. After a further 10
seconds, input mode is canceled with the message INP.IGN! and the input area is deleted.
All inputs sent to BS2000/OSD and all inputs canceled due to a timeout are placed in a
buffer. A maximum of ten inputs are stored in this way. They can be displayed, edited and
sent to BS2000/OSD again as needed. The following keys can be used to edit inputs:
[F1]
[F2]
[F3]
[F4]
[F5]
[F6]
[F7] - [F20]
¯
Ê
Ë
À
Â
Ú
[INSCHAR]
•
[DEL]
The key [F2] is also effective in the EVENT screen.
If the input is locked, the message KVP0071 and, in the KVP status line (line 1 on screen)
the message INP. LOCKED are output. You must then first permit input (Key F2 -> Permit
input).
When a command is input, the / prompt character of the BS2000 operating system must
also be specified in front of the BS2000 command.
Messages must be responded to in different ways depending on the type of message.
180
HELP (for dtterm)
Go to KVP menu screen
Scroll back in last inputs
Scroll forward in last inputs
Reserved
Reserved
Programmable function keys
Jump to character after next blank
Move cursor up
Move cursor down
Move cursor to right
Move cursor to left
Send entire input
Activate input mode
Delete character just before the cursor, close up text
Exit input mode
Operating BS2000 instances
U41272-J-Z385-3-76