Fujitsu Siemens Computers SX series User Manual page 165

Operating BS2000 instances
Use the functions Ë and Ê to select one of the following functions. When you have
selected the function, start the function with [ENTER]:
1 – Permit Input
You can permit input again. The valid password will be requested. If you supply an incorrect
password, the system will wait for approximately 6 seconds. This prevents an automated
trial and error attack.
2 – Inhibit Input
You can lock your screen against unauthorized inputs. If someone attempts to make an
input when it is locked, the message INP. LOCKED appears in the KVP status bar (i.e. in
screen line 1). In addition, an error message (KVP0071 ...) appears.
3 – Change Password
You can change the password of the Solaris login which is assigned to the used KVP ID.
You are asked to enter first the old password and then the new password (twice for security
reasons).
4 – View Last Messages
You can use this function to view the last 400 (approx.) messages. The last page is always
shown first. The start of the data is indicated by "S T A R T" in the first line. You can page
through the messages with the tool pg (see
To be able to see new incoming messages you must return to the BS2000 console screen.
U41272-J-Z385-3-76
page 174).
BS2000 console mode
165