Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 373

Ethernet Ring Protection Commands
Ring Port2
Ring Status
Service VLAN
WTR Timer (min)
Guard Timer (centi-sec) : 50,
MEG Level
Ring State
Ring Node Type
RPL Port
Last State Change
output definitions
Ring ID
Ring Ports
Ring Status
Service VLAN
WTR Timer
Guard Timer
MEG Level
Ring State
Ring Node Type
Last State Change
-> show erp port 1/15
Legend: * - Inactive Configuration
Ring-Id : 1
Ring Port Status
Ring Port Type
Ethoam Event
-> show erp port 1/1
Legend: * - Inactive Configuration
Ring Id : 1
Ring Port Status
Rint Port Type
Ethoam Event
Rmepid
output definitions
Ring ID
Ring Port Status
Ring Port Type
Ethoam Event
Rmepid
OmniSwitch CLI Reference Guide
: 1/1,
: enabled,
: 4094,
: 3,
: 2,
: idle,
: rpl,
: 1/1,
: SUN DEC 25 06:50:17 2016 (sysUpTime 00h:01m:31s)
The ERP ring ID number.
The slot and port number of the ring ports.
The ring status (enabled or disabled).
The Service VLAN ID.
The wait-to-restore timer value in minutes for RPL node.
The guard timer value in centi-secs for the ring node.
The Service VLAN Management Entity Group (MEG) level.
Indicates the state of the ring.
Indicates the type of the ring node.
Indicates the time when the last state change occurred.
: forwarding,
: non-rpl,
: disabled
: blocking,
: RPL,
: enabled,
: 10
The ERP ring ID number.
The status of the ring port (blocking or forwarding).
The type of ring port (RPL or non-RPL).
Indicates whether or not the ring port will accept Ethernet OAM loss of
connectivity events (enabled or disabled).
The remote Ethernet OAM MEP ID number from which this port
accepts loss of connectivity events. This field displays only when the
ring port is configured to receive such events.
March 2011
show erp
page 8-13