Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 358

show multi-chassis consistency linkagg
Output fields are defined here:
output definitions
Consistency
Local
Peer
Status
Chassis-ID
Aggregate-ID
LAG-Type
LACP-System-ID
LACP-Priority
Default-Vlan
VLAN List
Release History
Release 7.1.1; command introduced.
Related Commands
linkagg range
MIB Objects
multiChassisLinkaggConsistencyTable
multiChassisLinkaggAggIndex
multiChassisLinkaggAggIndexConsistency
multiChassisLinkaggLocalAggType
multiChassisLinkaggPeerAggType
multiChassisLinkaggAggTypeConsistency
multiChassisLinkaggLocalVlanType
page 7-34
Provides a list of per-multi-chassis aggregate optional consistency
parameters for the local and remote switches operating in multi-chassis
mode.
Value of a given consistency parameter on the local switch.
Value of a given consistency parameter on the peer switch.
Specifies the overall status of a consistency parameter within the entire
multi-chasiss system comprised by the individual switches. The possi-
ble values are OK, NOK or N/A. or If there is a mismatch of any of the
parameters listed in this command or if the chassis identifier of the two
switches is the same, the multi-chassis operational status will not
become Up. In this case the "Status" column shown in this output will
indicate which parameter has a problem. The N/A value in the "Peer"
column indicates that the information is unavailable from the peer. This
will always be the case when the multi-chassis operational status is
Down.
Globally unique chassis identifier. The valid range for the multi-chassis
operational range is [1 - 2], whereas the value for standalone operation
is zero.
The number corresponding to the static or dynamic multi-chassis aggre-
gate group within the range [0-127].
Defines the aggegate type as static or dynamic, i.e. LACP
Specifies the system identifier (MAC address format) used by the
LACP protocol.
Provides the system priority used by the LACP protocol.
Specifies the value of the default VLAN configured on the multi-chas-
sis aggregate within the range [1 - 4094].
Indicates whether other types of VLANs (distinct from the default
VLAN) are configured on the multi-chassis aggregate.
Displays information about static and dynamic (LACP) aggregate
groups.
Multi-Chassis Commands
OmniSwitch CLI Reference Guide March 2011