Configure Rf-Profile Rts-Threshold - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

configure rf-profile rts-threshold

configure rf-profile <name> rts-threshold <value>
Description
Specifies the request to send (RTS) threshold in bytes.
Syntax Description
name Specifies the names of the RF profile.
value Specifies the RTS threshold in bytes. Valid values are from 0 to 2347.
Default
2330 bytes
Usage Guidelines
Should you encounter inconsistent data flow, only minor modifications are recommended. If a network
packet is smaller than the preset RTS threshold size, the RTS and clear-to-send (CTS) mechanism is not
enabled. The wireless port sends RTS frames to a particular receiving station and negotiates the sending
of a data frame. After receiving an RTS, the wireless station responds with a CTS frame to acknowledge
the right to begin transmission.
Examples
The following command sets the RTS threshold to the default setting:
configure rf-profile rfprof1 rts-threshold 2330
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p and Alpine switches.
1260 ExtremeWare 7.5 Command Reference Guide