Extreme Networks ExtremeWare Command Reference Manual page 1733

Hide thumbs Also See for ExtremeWare:

Table of Contents

configure ospf add vlan area

In either case, LDP must be configured to advertise label mappings for direct routing interfaces.

In some configurations, you may want to enable loopback mode on the VLAN to which the tunnel

endpoint IP address is assigned. One situation where loopback mode may be useful is when multiple

physical interfaces, associated with different VLANs, are connected to the MPLS backbone. In this case,

use of loopback-mode can provide redundancy by enabling TLS traffic to continue even when the

physical interfaces associated with the tunnel endpoint IP address VLAN fail.

The following command enables OSPF on a VLAN named accounting:

configure ospf add vlan accounting area 0.0.0.1

This command was first available in ExtremeWare 2.0.

This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare

v6.1.8b12 to support MPLS modules.

This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.

This command was modified in an ExtremeWare 7.2e to support the

Platform Availability

This command is available on all platforms.

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5