Enable Icmp Parameter-Problem - Extreme Networks ExtremeWare Command Reference Manual

IP Unicast Commands

enable icmp parameter-problem

enable icmp parameter-problem {vlan <vlan name>}
Description
Enables the generation of an ICMP parameter-problem message on one or all VLANs.
Syntax Description
vlan name Specifies a VLAN name.
Default
Enabled
Usage Guidelines
Enables the generation of an ICMP parameter-problem message (type 12) when the switch cannot
properly process the IP header or IP option information. If a VLAN is not specified, the command
applies to all IP interfaces.
This command only affects the generation of certain ICMP packets. Filtering of ICMP packets usually
forwarded by the switch is controlled by the access-list commands.
Example
The following command enables the generation of an ICMP parameter-problem message on VLAN
accounting:
enable icmp parameter-problem vlan accounting
History
This command was first available in ExtremeWare 6.1.
This command was added to the "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
1660 ExtremeWare 7.5 Command Reference Guide