Extreme Networks ExtremeWare Command Reference Manual page 1688

IP Unicast Commands
Following is sample output from this command:
Router Interface[1] on VLAN test is enable and up.
UDP Forwarding profile: none.
inet 11.3.3.4 netmask 0xffffff00 broadcast 11.3.3.255
Secondary: inet 11.4.3.4 netmask 0xffffff00 broadcast 11.4.3.255
Multicast ttl 1 metric 1 mtu 1500
Locally registered multicast address (Last Querier=11.3.3.4):
224.0.0.1
Flags:
AddrMaskRly
ESRP
IgnoreBcast
ISIS
MPLS
PIM
SendPortUn YES
SLB-Cli
VRRP
History
This command was first available in ExtremeWare 2.0.
This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare
v6.1.8b12 to support MPLS modules.
The output for this command was changed to accommodate the multinetting feature by including
secondary IP addresses. This modified command was made available in ExtremeWare 7.3.0.
This command was added to the "e" series of switches in ExtremeWare 7.1e.
This command was modified in ExtremeWare 7.2e to support the
Platform Availability
This command is available on all platforms.
1688
NO BOOTP Host NO
NO Fwd Bcast NO
NO IP Fwding NO
NO ISQ NO
NO NAT-Inside NO
NO RIP NO
Send Redir YES
NO SLB-Srv NO
NO
DirBcstHwFwd NO
IGMP YES
IPmc Fwd NO IRDP Advert
LDP NO LPM-routing
NAT-Outside NO
RSVP NO
SendTimxceed YES SendUnreach YES
SubVLAN Prxy YES TimeStampRly
keyword.
detail
DVMRP NO
IGMP Ver V2
NO
NO
OSPF NO
SendParam YES
NO
ExtremeWare 7.5 Command Reference Guide