Wireless Commands
configure wireless ports interface ap-scan probe-interval
configure wireless ports [<portlist> | all] interface [1 | 2] ap-scan
probe-interval <msec>
Description
Use this command to configure the interval between probe request packets for active off-channel
scanning.
Syntax Description
portlist
all
interface
msec
Default
100 ms.
Usage Guidelines
Use this command to send probe requests at particular intervals on a selected channel during an access
point (AP) scan.
Example
The following example configures the interval between probe request packets to be 10 ms for port 1:9
on interface 2:
configure wireless ports 1:9 interface 2 ap-scan probe-interval 10
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p and Alpine switches.
1276
Specifies one or more ports or slots and ports. an be one or more port
numbers. May be in the form 1, 2, 1:2, 3-5.
Specifies all ports.
Specifies an interface: 1 or 2.
Specifies the time between probe request packets in milliseconds. Valid
entries are between 50 and 3600000 milliseconds.
ExtremeWare 7.5 Command Reference Guide