Configure Ospf Timer - Extreme Networks ExtremeWare Command Reference Manual

IGP Commands

configure ospf timer

configure ospf [vlan <vlan name> | area <area identifier> | virtual-link
<routerid> <area identifier>] timer <retransmit interval> <transit delay>
<hello interval> <dead interval> {<wait timer interval>}
Description
Configures the timers for one interface or all interfaces in the same OSPF area.
Syntax Description
vlan name
area identifier
routerid
retransmit interval
transit delay
hello interval
dead interval
wait timer interval
Default
• retransmit interval—Default: 5
• transit delay—Default: 1
• hello interval—Default: 10
• dead interval—Default: 40
• wait timer interval—Default: dead interval
Usage Guidelines
Configuring OSPF timers and authentication on a per-area basis is a shorthand for applying the timers
and authentication to each VLAN in the area at the time of configuration. If you add more VLANs to
the area, you must configure the timers and authentication for the new VLANs explicitly.
Example
The following command sets the timers on the virtual link in area 0.0.0.2:
configure ospf virtual-link 6.6.6.6 0.0.0.2 timer 10 1 20 200
History
This command was available in ExtremeWare 2.0.
1756
Specifies a VLAN name.
Specifies an OSPF area.
Specifies a router number.
Specifies the length of time that the router waits before retransmitting an LSA
that is not acknowledged. The range is 0 - 3,600 seconds.
Specifies the length of time it takes to transmit an LSA packet over the
interface. The range is 0 - 3,600 seconds.
Specifies the interval at which routers send hello packets. The range is 1 -
65,535 seconds.
Specifies the interval after which a neighboring router is declared down due to
the fact that hello packets are no longer received from the neighbor. The
range is 1 - 2,147,483,647 seconds.
Specifies the interval between the interface coming up and the election of the
DR and BDR. Usually equal to the dead timer interval.
ExtremeWare 7.5 Command Reference Guide