Extreme Networks ExtremeWare Command Reference Manual page 1692

IP Unicast Commands
indicate the presence of MPLS next hops. An uppercase
hop for the route. A lowercase
On the "i" series of switches only. An optional
command. When the
mpls
information normally displayed is omitted, and the LSP endpoint and outgoing MPLS label are
displayed instead. The LSP endpoint is the IP address/prefix of the FEC associated with the LSP. The
LSP endpoint matches the destination for direct LSPs and is a 32-bit prefix address of a proxy router for
indirect LSPs.
The keyword only applies to some of the options available on the show iproute command. The
mpls
s keyword is ignored when specified in conjunction with the following options:
mpl
• priority
• route-map
• summary
If a route is active and in use, it is preceded in the display by an "*". If there are multiple routes to the
same destination network, the "*" will indicate which route is the most preferable route.
The and fields indicate the number of times the route table entry is being used for packet
Use M-Use
forwarding decisions. The
a count for multicast routing. If the use count is going up unexpectedly, the software is making route
decisions and should be investigated further.
Example
The following command displays detailed information about all IP routing:
show iproute detail
Following is the output from this command:
Destination: 10.10.121.111/30
Gateway: 10.10.121.201
Metric : 1
Use : 14409
Destination: 10.11.166.112/29
Gateway: 10.17.0.1
Metric : 2
Use : 0
Destination: 10.13.105.112/29
Gateway: 10.11.110.123
Metric : 2
Use : 0
History
This command was available in ExtremeWare 2.0.
This command was modified in an ExtremeWare IP Technology Services Release based on ExtremeWare
6.1.8b12 to support MPLS modules.
1692
indicates the presence of an indirect LSP next hope for the route.
l
mpls
keyword is specified, the information displayed is modified; some of the
field indicates a count for unicast routing while the
Use
VLAN : helium
Flags : U------u-
M-Use : 0
VLAN : helium
Flags : UG-----um
M-Use : 0
VLAN : helium
Flags : UG-----um
M-Use : 0
indicates the presence of a direct LSP next
L
keyword has been added to the
Origin : *d
Time : 13:15:26:49
Acct-1 : 0
Origin : *be
Time : 01:11:23:49
Acct-1 : 0
Origin : *be
Time : 00:29:09:23
Acct-1 :
show iproute
field indicates
M-Use
ExtremeWare 7.5 Command Reference Guide