Configure Ospf Area External-Filter - Extreme Networks ExtremeWare Command Reference Manual

configure ospf area external-filter

configure ospf area <area identifier> external-filter [<access profile>
|none]
Description
Configures an external filter policy.
Syntax Description
area identifier
access profile
none
Default
N/A.
Usage Guidelines
For switches configured to support multiple OSPF areas (an ABR function), an access profile can be
applied to an OSPF area that filters a set of OSPF external routes from being advertised into that area.
NOTE
If any of the external routes specified in the filter have already been advertised, those routes will remain
until the associated LSAs in that area time-out.
Using the none mode specifies that no external filter is applied.
Example
The following command configures an external filter policy from the access profile nosales:
configure ospf area 1.2.3.4 external-filter nosales
History
This command was first available in ExtremeWare 4.0.
This command was added to the Summit "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
Specifies the OSPF target area.
Specifies an access profile.
Specifies not to apply an external filter.
configure ospf area external-filter
1737