Disable Red Ports Queue - Extreme Networks ExtremeWare Command Reference Manual

Hide thumbs Also See for ExtremeWare:

Table of Contents

PoS Commands—BlackDiamond Switch Only

disable red ports queue

disable red ports <portlist> queue <queue#>

Disables RED on the specified ports.

Syntax Description

Usage Guidelines

keyword has been added to support the PoS module. Currently, this new keyword is only

applicable to PoS ports. The keyword allows the RED function to be selectively enabled on an

individual queue basis. The

omitted, then the command applies to all egress queue numbers for the PoS port(s). RED is not

supported on the ingress queues.

The following command disables RED for all PHBs except the EF PHB:

disable red ports 2:1-2:2 queue 8

This command was modified in an ExtremeWare IP Technology Services Release based on v6.1.5b20 to

support PoS modules.

Platform Availability

The general form of this command is available on all platforms. The optional queue parameter is

available only on the PoS module on a BlackDiamond switch.

Specifies the port number(s). May be in the form 1, 2, 3-5, 2:5, 2:6-8.

Specifies the queue for which the RED function is disabled. This parameter is

supported for the PoS module only.

# parameter is an integer in the range [0-7]. If the

ExtremeWare 7.5 Command Reference Guide

Extremeware 7.5