Configure Wanqos Egress Map Dot1P_Priority - Extreme Networks ExtremeWare Command Reference Manual

T1, E1, and T3 WAN Commands—Alpine 3800 Series Platforms

configure wanqos egress map dot1p_priority

configure wanqos egress map dot1p_priority <priority> to qosprofile <QoS
profile>
Description
Change the default mapping of dot1p values to software egress queues.
Syntax Description
priority
qosprofile
Default
N/A
Usage Guidelines
WAN QoS uses dot1p value to map directly to software egress queues. Use this command to change the
default mapping and map several dot1p values to the same software queue. This can simplify
configuration (two to three classes of service instead of eight) and improve egress burst tolerance
because each queue can have a larger number of buffers. Set the maximum buffer size to one for unused
queues.
To set the maximum buffer size on queues, use the following command:
configure qosprofile <qosprofile> wanqos maxbuf <count> [ports <portlist> |
multilink <multilink name>]
Example
The following command maps dot1p priority 5 to QoS profile qp7:
configure wanqos egress map dot1p_priority 5 to qosprofile qp7
History
This command was available in ExtremeWare 7.1.0.
Platform Availability
This command is available for T1 and E1 modules.
2200
Specifies a dot1p priority.
Specifies a QoS profile name.
ExtremeWare 7.5 Command Reference Guide