Enable Stacking - Extreme Networks ExtremeWare Command Reference Manual

Stacking Commands

enable stacking

enable stacking [port <port_list>]
Description
This command enables stacking on the specified port.
Syntax Description
port_list Specifies to enable stacking on one or more ports.
Default
The enable stacking command defaults to the following on the listed platforms:
Table 27: Stacking Default Ports
Platform
Summit 200-24
Summit 200-48
Summit 300-24
Summit 400-24
Summit 400-48
Usage Guidelines
Use this command to enable stacking on the port list. After stacking is enabled, the port number
appears as a slot and port combination, such as 1:49,1:50. If the slot and port format is not present, the
command applies to the current switch.
Example
The following command enables stacking using the default ports:
enable stacking
The following command enable stacking using unique ports:
enable stacking ports 5,6
History
This command was first available in ExtremeWare 7.4.
Platform Availability
This command is only available on the Summit 200, Summit 300-24, and Summit 400 switches.
1396
Default
enable stacking port 25,26
enable stacking port 49,50
enable stacking port 25,26
enable stacking port 25,26
enable stacking port 52,53
ExtremeWare 7.5 Command Reference Guide