Configure Stpd Tag - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd tag

configure stpd <spanning tree name> tag <vlan tag>
Description
Assigns an StpdID to an STPD.
Syntax Description
spanning tree name Specifies an STPD name on the switch.
vlan tag Specifies the VLANid of a VLAN that is owned by the STPD.
Default
N/A
Usage Guidelines
You should not configure any STP parameters unless you have considerable knowledge and experience
with STP. The default STP parameters are adequate for most networks.
An STPD identifier (StpdID) is used to identify each STP domain. You assign the StpdID when
configuring the domain. An StpdID must be identical to the VLANid of one of the member VLANs in
that STP domain, and that VLAN cannot belong to another STPD. Unless all ports are running in 802.1d
mode, an STPD must be configured with an StpdID.
You must create and configure the VLAN, along with the tag, before you can configure the STPD tag. To
create a VLAN, use the
create vlan
command.
In addition to the VLAN attributes that you will use in the STPD, you must first create an STPD. To
create an STPD, use the
delete stpd
Example
The following command assigns an StpdID to the STPD called purple_st:
configure stpd purple_st tag 200
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
1456
command. To configure the VLAN, use the
command.
configure vlan
ExtremeWare 7.5 Command Reference Guide