Configure Wireless Ports Interface Transmit-Rate - Extreme Networks ExtremeWare Command Reference Manual

Wireless Commands

configure wireless ports interface transmit-rate

configure wireless ports <portlist> interface [1 | 2] transmit-rate <rate>
Description
Configures a transmission rate for the specified port.
Syntax Description
portlist Specifies one or more ports or slots and ports. an be one or more port numbers. May be in the form
1, 2, 1:2, 3-5.
interface Specifies an interface: 1 or 2.
rate Specifies the transmission rate for the port. Entering auto specifies automatic transmission rate
selection. Valid values are shown in Table 24.
Default
54 Mbps
Usage Guidelines
Each wireless port on the Summit 300 contains two interfaces. Interface 1 supports 802.11a, and interface
2 supports 802.11b/g radio signals. The
command allows you to configure the transmission rate for one of the two individual interfaces (1|2) on
a port or ports.
Valid transmission rate values are shown in Table 24.
Table 24: Valid transmission rate values
Mode Valid Transmission Rate
A 6, 9, 12, 18, 24, 36, 48, 54, auto
B 1, 2, 5.5, 11, auto
G 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, 54, auto
Example
The following command configures the port 14 on a Summit 300-24 to transmit at 54 Mbps for both
interface 1 and 2 (A and G):
configure wireless port 14 interface 1 transmit-rate 54Mbps
configure wireless port 14 interface 2 transmit-rate 54Mbps
History
This command was first available in ExtremeWare 6.2a and added to the "e" series in 7.3e.
Platform Availability
This command is available on the Summit 300-48, Summit 300-24, Summit 400-24p and Alpine switches.
1294
configure wireless port interface transmit-level
ExtremeWare 7.5 Command Reference Guide