Configure Eaps Hellotime - Extreme Networks ExtremeWare Command Reference Manual

EAPS Commands

configure eaps hellotime

configure eaps <name> hellotime <seconds>
Description
Configures the value of the hello timer the master node used for the EAPS health-check packet.
Syntax Description
name
seconds
Default
Default is 1 second.
Usage Guidelines
Use the keyword and its associated
hellotime
master node waits between transmissions of health-check packets on the control VLAN. Increasing the
value keeps the processor from sending and processing too many health-check packets.
hellotime
Increasing the
hellotime
are already sending "link down" notifications.
This command applies only to the master node. If you configure the polling timers for a transit node,
they will be ignored. If you later reconfigure that transit node as the master node, the polling timer
values will be used as the current values.
Example
The following command configures the hellotime value for the EAPS domain "eaps_1" to 2 seconds:
configure eaps eaps_1 hellotime 2
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
1412
Specifies the name of an EAPS domain.
Specifies the number of seconds to wait between transmission of the
health-check packets on the control VLAN. Must be greater than 0.
seconds
value should not affect the network convergence time, because transit nodes
parameter to specify the amount of time the
ExtremeWare 7.5 Command Reference Guide