Configure Aps Lockout - Extreme Networks ExtremeWare Command Reference Manual

PoS Commands—BlackDiamond Switch Only

configure aps lockout

configure aps <group#> lockout [off | on]
Description
Controls whether a switch to the protection line is locked out.
Syntax Description
group#
off
on
Default
The default is .
off
Usage Guidelines
The identifies the APS group that the
group#
specified, switches from the working line to the protection line are prohibited, until you subsequently
issue a command. The default is lockout off. This command is only applicable to SONET
lockout off
ports performing the protection line function. Additionally, the effects of this command are not
preserved across a switch reboot.
Example
The following command example turns on lockout mode for APS group
config aps 1001 lockout on
History
This command was first available in an ExtremeWare IP Technology Services Release based on
v6.1.5b20.
Platform Availability
This command is available on the BlackDiamond switch only.
2114
Specifies the APS group# to which the command applies.
Specifies that switches from the working line to the protection line are allowed.
Specifies that switches from the working line to the protection line are
prohibited.
command applies to. When
lockout
is
lockout on
:
1001
ExtremeWare 7.5 Command Reference Guide