Configure Stpd Ports Mode - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

configure stpd ports mode

configure stpd <spanning tree name> ports mode [dot1d | emistp | pvst-plus]
<portlist>
Description
Configures the STP mode of operation for the specified port list.
Syntax Description
spanning tree name Specifies an STPD name on the switch.
dot1d Specifies IEEE 802.1d-compliant packet formatting. A physical port can only be a member
of one STPD running it dot1d mode.
emistp Specifies 802.1d formatting and 802.1q tagging.
pvst-plus Specifies PVST+ packet formatting.
portlist Specifies one or more ports or slots and ports. On a modular switch, can be a list of slots
and ports. On a stand-alone switch, can be one or more port numbers. May be in the form
1, 2, 3-5, 2:*, 2:5, 2:6-2:8.
Default
Ports in the default STPD (s0) are
Usage Guidelines
None.
Examples
The following command configures STPD s1 with PVST+ packet formatting for port 1 on a stand-alone
switch:
configure stpd s1 ports mode pvst-plus 1
The following command configures STPD s1 with PVST+ packet formatting for slot 2, port 1 on a
modular switch:
configure stpd s1 ports mode pvst-plus 2:1
History
This command was first available in ExtremeWare 6.2.
This command was added to the Summit "e" series of switches in ExtremeWare 7.2e.
Platform Availability
This command is available on all platforms.
1452
mode. Ports in user-created STPDs are in
dot1d
mode.
emistp
ExtremeWare 7.5 Command Reference Guide