Configure Iproute Add Default - Extreme Networks ExtremeWare Command Reference Manual

configure iproute add default

configure iproute add default <gateway> {<metric>}
Description
Adds a default gateway to the routing table.
Syntax Description
gateway Specifies a VLAN gateway
metric Specifies a cost metric. If no metric is specified, the default of 1 is used.
Default
If no metric is specified, the default metric of 1 is used.
Usage Guidelines
Default routes are used when the router has no other dynamic or static route to the requested
destination. A default gateway must be located on a configured IP interface. Use the
multicast-only
traffic uses the default route.
Example
The following command configures a default route for the switch:
configure iproute add default 123.45.67.1
History
This command was available in ExtremeWare 2.0.
This command was added to the "e" series of switches in ExtremeWare 7.1e.
Platform Availability
This command is available on all platforms.
ExtremeWare 7.5 Command Reference Guide
options to specify a particular traffic type. If not specified, both unicast and multicast
configure iproute add default
or
unicast-only
1609